|
Easter
Bunny "Oops"
Designed By: Cindy Groom Harry & Staff
Typical
Project Completion Time: 1-2 hours
(does not include drying time)
Download
pattern
(12K pdf)
|
MATERIALS
NEEDED:
STYROFOAM* Brand Products:
one 2-3/8" Long Egg
one 4" Ball
Other Materials:
one RenuzitŪ Adjustable Air Freshener
one 4" Clay Pot, 3 1/2" High
Acrylic Paint: White, Pink
Natural Sea Sponge
Felt: one 1" x 5 1/2" Piece Pink; one 6"x 9" Piece White
one 2" White Pom
Green Paper Crimps
Miscellaneous Items:
Low-temp glue gun & glue sticks, serrated knife, metal
spoon, paint brush, tracing paper, pencil, scissors, toothpicks
and paper towels.
| INSTRUCTIONS: |
| 1.
FLOWER POT: Dip damp sea sponge in Pink paint. Blot excess off
on paper towel. Lightly sponge paint pot; let dry. Repeat process
using White paint. Cut paper crimps into approximately 3" lengths.
Apply glue to inside top edge of clay pot. Press ends of paper
crimps into glue, allowing paper crimps to drape over clay pot
edge. Place RenuzitŪ Air Freshener in clay pot. Trace bottom
of pot onto white felt, cut out, trim if needed and glue to
pot. |
| 2.
BODY: Using metal spoon, carve out inside of ball of STYROFOAM
to fit on air freshener. Paint body White; let dry. Place body
onto topper. |
| 3.
TAIL: Trim one end of pom to make flat surface and glue to body,
centered above feet. Trim top of pom if necessary. |
| 4.
FEET: Cut foam egg in half lengthwise for feet. Using back of
metal spoon, round cut edges of egg. Use spoon to shape three
toes on large round end of each foot. Paint feet White; let
dry. From white felt, cut two feet according to pattern. Glue
to bottom of feet and trim as necessary. From pink felt, cut
two large foot pads and six small foot pads according to patterns.
Position and glue to bottom of feet. Poke toothpick into top
of feet. Position feet onto body just above pot rim, approximately
1 1/2" apart; secure with glue. |
| 5.
GEL REPLACEMENT: When the original gel is depleted, simply replace
with a new air freshener. For future projects: if your project
base is decorated, remove dried gel. From a new container, remove
new, non-toxic gel, then slip it over the post of the decorated
base and reposition the decorated topper. |
|
|